Alternator Drive Belt Piaggio Porter 1.3 16V


By Christian Sorbello
2 minute read

Cinghia comando alternatore Piaggio Porter 1.3 16V

Hello to all Piaggio Porter enthusiasts, in this article we'll show you how to adjust the alternator belt.

  1. First, tighten the adjusting bolt until theCinghia comando alternatore Piaggio Porter 1.3 16V

    deflection of the drive belt reaches the
    specified value. Check the belt by pressing the
    middle section between the water pump
    pulley and the alternator pulley,
    applying a force of 98 N.
  2. Once done, tighten the alternator locking screws.
    KEY:

    Cinghia comando alternatore Piaggio Porter 1.3 16V1.
    Water pump pulley
    2. V-belt
    3. Crankshaft pulley
    4. Alternator pulley
    5. Force application point
    6. Straight edge
    7. Degree of deflection

We'll also show you how to inspect your belt for wear, here's how:

  1. Inspect the belt for any signs of separation from the adhesive rubberCinghia comando alternatore Piaggio Porter 1.3 16V

    on the top or bottom of the belt,
    separation of the belt core from the sides, fraying
    of the belt core, fraying
    of the adhesive rubber weave, cracking or
    separation of the ribs, tears or cracks
    in the inner ribs of the belt. Replace the
    drive belt if necessary.
  2. Measure the deflection (shown by the arrow) of the driveCinghia comando alternatore Piaggio Porter 1.3 16V

    belt when a force of 98
    N (10 Kgf) is applied at the middle of the belt,
    between the alternator pulley (B) and the water
    pump pulley (A)

Finally, we'll explain the difference between a new belt and a used one.

• A "NEW BELT" IS DEFINED AS A BELT THAT HAS BEEN USED FOR LESS THAN FIVE MINUTES ON A RUNNING ENGINE.
• A "USED BELT" IS DEFINED AS A BELT THAT HAS BEEN USED FOR MORE THAN FIVE MINUTES ON A RUNNING ENGINE.
• AFTER FITTING A NEW BELT, RUN THE ENGINE FOR AT LEAST FIVE MINUTES AND THEN CHECK THE TENSION AGAIN.