Bleeding Air from the Braking System on the Piaggio Porter NP6


By Christian Sorbello
2 minute read

Spurgo dell'Aria dall'Impianto Frenante del Piaggio Porter NP6 - Mondo Porter

Complete Guide to Bleeding Air from the Braking System on the Piaggio Porter NP6

Regular servicing of the braking system is essential to ensure the safety of your Piaggio Porter NP6. One of the key jobs is bleeding the air from the brake system. In this guide, we will show you step by step how to carry out this operation correctly, improving search engine visibility thanks to SEO best practices.

Introduction

Bleeding the air from the braking system is an essential procedure for maintaining brake efficiency and safety. Air trapped in the system can significantly reduce braking capacity, putting the vehicle's safety at risk. Follow the instructions below carefully to carry out this operation on your Piaggio Porter NP6.

Tools Required

Before you begin, make sure you have the following tools to hand:

  • Torque wrenches
  • Ratchet spanner set
  • Clear bleed tube
  • Container for collecting brake fluid
  • Brake fluid
  • Vehicle lift

Air Bleeding Procedure

  1. Preparing the Vehicle:

    • Position the vehicle on the lift.
    • Disconnect the negative battery terminal to avoid short circuits.
    • Make sure the brake fluid reservoir is full.
  2. Connecting the Bleed Tube:

    • Connect one end of the clear tube to the bleed screw on the rear right brake drum and the other end to the fluid collection container.
  3. Bleeding Operation:

    • Raise the vehicle.
    • Press the brake pedal at least ten times and hold it down.
    • Undo the drum's bleed screw, allowing the fluid and air to flow out through the tube.
    • Repeat the operation until only brake fluid free of air bubbles comes out.
  4. Repeating the Process:

    • Fully release the brake pedal and repeat the bleeding operation four times, keeping the pedal pressed while the bleed valve is open.
    • Close the bleed screw, release the brake pedal and wait two seconds for the fluid to settle.

  1. Checking the Fluid Level:

    • During bleeding, make sure the brake fluid reservoir is always full to prevent air from entering the system.

  1. Repeating for All the Brakes:

    • Repeat the procedure described for the rear right, front left and front right brakes, making sure to keep the brake fluid level topped up at all times.

Final Considerations

Once the air bleeding operation is complete, it is important to check that the brakes work correctly:

  • Start the engine and press the brake pedal repeatedly to make sure there are no fluid leaks.
  • Lower the vehicle and check that the fluid level in the reservoir is at the MAX mark.
  • Close the reservoir by screwing on the cap.