Brake Servo Replacement Guide for the Piaggio Porter NP6
Complete Guide to Replacing the Brake Servo on the Piaggio Porter NP6
The brake servo is an essential component of the braking system on your Piaggio Porter NP6, ensuring efficient, safe braking. In this guide, we provide all the instructions you need to remove and refit the brake servo, with content optimised for search engines thanks to SEO best practices.
Introduction
Servicing the brake servo is crucial to keeping your vehicle's braking system in optimal condition. A faulty brake servo can compromise driving safety, making its replacement essential when needed. Follow the steps described below to carry out this operation correctly on your Piaggio Porter NP6.
Tools Required
Before you begin, make sure you have the following tools to hand:
- Torque wrenches
- Ratchet spanner set
- Vehicle lift
- Containers for collecting fluids
Removing the Brake Servo
-
Preparing the Vehicle:
- Position the vehicle on the lift.
- Disconnect the negative battery terminal to avoid short circuits.
-
Removing the Front Components:
- Remove the upper front panel and the bumper.
- Drain the cooling and air-conditioning systems.
- Remove the air-conditioning condenser and the radiator.
- Drain the brake/clutch system and remove the front-compartment lock support cross member.
-
Disconnecting the Pipes and Connections:
- Disconnect the brake/clutch fluid pipe on the clutch master cylinder side and the electrical connection of the brake/clutch fluid level sensor.
- Undo the unions and disconnect the rigid oil pipes from the brake master cylinder.
- Disconnect the vacuum pipe from the brake servo.
-
Removing the Brake Servo:
- Remove the split pin and the fixing pin from the brake pedal and disconnect the brake servo pushrod.
- Working from inside the cab, undo the brake servo fixings to the pedal box.
- Remove the brake servo complete with the brake master cylinder and the brake/clutch fluid reservoir.

Refitting the Brake Servo
-
Assembling the Brake Master Cylinder to the Brake Servo:
- If separated, position the brake master cylinder on the brake servo and tighten the fixing nuts to the specified torque.
-
Installing the Brake Servo:
- Fit the brake servo, complete with the brake master cylinder and fluid reservoir, into position.
- From inside the cab, tighten the brake servo fixings to the pedal box to the specified torque (18 - 23 Nm).
-
Reconnecting the Pipes and Connections:
- Connect the brake servo pushrod to the brake pedal using the fixing pin and insert the split pin.
- Connect the vacuum pipe to the brake servo.
- Connect the rigid oil pipes to the brake master cylinder and tighten the unions to the specified torque (16 ± 2 Nm).
- Connect the electrical connection of the brake/clutch fluid level sensor and the brake/clutch fluid pipe on the clutch master cylinder side, tightening the fixing clip.
-
Refitting the Front Components:
- Fit the front-compartment lock support cross member.
- Charge the brake/clutch system, the air-conditioning system and the cooling system.
- Fit the radiator and the air-conditioning condenser.
- Refit the bumper and the upper front panel.
Final Considerations
Once you have finished refitting the brake servo, it is essential to check that the braking system works correctly. Carry out a road test to make sure the brakes respond properly and that there are no fluid leaks.