Coolant Replacement Piaggio Porter 1.3 16V
Are you wondering how to change the coolant?
No problem, we'll show you how.
First of all, we remind you to NEVER open the radiator cap or the drain plug while the engine is hot.
A. Set the heater control lever
to the "hot" position. B. Remove the radiator cap (No.3 in the figure alongside.)
C. Drain the coolant by removing the
drain plugs located on the lower tank of the
radiator and the radiator hose.
D. Remove the plug (No.2 in the figure alongside) on the engine side and the plug (No.1 in the figure alongside)
of the heater bleed pipe on the upper part
of the engine.

E. Insert a hose into the radiator filler hole.
Flush the inside of the radiator. During this
operation keep the engine at idle.
F. Switch off the engine and refit the drain plugs
and close them.
G. Pour the coolant into the radiator.
When the coolant begins to flow out
of the hole (No.2 in the figure alongside) on the engine side and from the
heater bleed pipe, close both
openings.
H. Add coolant until it
flows out of the radiator filler hole.
I. Fully tighten the radiator cap (No.3 in the first figure.)
L. Clean the inside of the expansion tank and fill it
with coolant.

M. Start the engine and let it reach operating temperature.
N. Always check that there are no leaks.
O. Once the coolant temperature has dropped,
remove the plug (No.2 in the figure alongside) located on the engine side. Check the coolant level. If the level is too low, top up with coolant.
Refit the plug (No.2 in the figure alongside.)
P. Check the coolant level in the
expansion tank. Top
up with water to the maximum level. Refit the expansion tank cap.
Finally, fill the radiator with coolant and connect the tester to the radiator cap. Warm up the engine and apply a pressure of 117kPa with the tester fitted to the radiator cap, and always check for leaks.
