Fitting – Removing – Piaggio Porter Crankshaft Pulley


By Christian Sorbello
1 minute read

Montaggio - Smontaggio - Puleggia Albero Motore Piaggio Porter - Mondo Porter

Removing Crankshaft Pulley Piaggio Porter

Before removing the drive pulley from the crankshaft, you must lock the rotation from the opposite side of the engine block using the specific tool.

puleggia albero motore piaggio porter b010046

1 - Undo the central screw of the pulley.

puleggia albero motore piaggio porter b010046

2 - Remove the central screw and clean off any sealant residue.

puleggia albero motore piaggio porter b010046

3 - Remove the pulley from the crankshaft.

puleggia albero motore piaggio porter b010046

Before fitting the crankshaft drive pulley, you must clean the surfaces and threads.

puleggia albero motore piaggio porter b010046

Apply the recommended sealant to the screw flange.

Recommended products
HZ 1213 oil-resistant silicone sealant. Colour «Grey».

puleggia albero motore piaggio porter b010046

 Fit the pulley and tighten to the torque specified below 

Tightening torques (N*m)

Pulley (a) - Crankshaft 115 Nm

puleggia albero motore piaggio porter b010046