Piaggio Porter NP6 Engine Oil
Here is a short guide to help you change the engine oil and oil filter on your Piaggio Porter Np6 yourself
What engine oil does the Piaggio Porter Np6 take?
The engine oil for the Piaggio Porter Np6 recommended is 10W-40, a lubricant with synthetic bases for four-stroke engines.
SAE 10W-40; JASO MA, MA2; API SL; ACEA A3
How to Check the Engine Oil Level on the Porter Np6
Here is the mini guide to check the engine oil level on your Piaggio Porter Np6:
1 - Park the vehicle on a level surface and warm up the engine until it reaches normal operating temperature, then switch it off.
2 - After a few minutes, slowly pull out the oil dipstick and wipe it clean

3 - Reinsert the dipstick all the way
4 - Pull the dipstick out again and check that the oil level is between the «MIN» and «MAX» marks.

5 - If the engine oil level is too low, top up only with the recommended type of oil
Oil Change on the Piaggio Porter Np6
Here is a short guide to help you change the engine oil and oil filter on your Piaggio Porter Np6 yourself
Start the engine and warm it up for a few minutes, then switch it off and place the vehicle on the lift
1 - Unscrew the engine oil filler cap on the rocker cover located under the left-hand seat
2 - Raise the lift, get a suitable container and unscrew the engine oil drain plug

3 - Using the proper spanner, unscrew the engine oil filter. Check and clean the filter seating surface.

4 - Lubricate the sealing ring of the new oil filter with engine oil before fitting it.

5 - Screw on by hand until the sealing ring comes into contact with the mounting surface.
Then tighten the engine oil filter appropriately.
6 - Tighten the plug of the engine oil sump.

Tightening torques (N*m)
Oil sump cover - Oil sump 11,0 ± 1,0 Nm
7 - Lower the lift and, using a funnel, fill with engine oil.

Recommended products
https://www.mondoporter.com/en/products/olio-motore-porter-castrol-10w-40
Engine oil 10W-40 Lubricant with synthetic bases for four-stroke engines.
SAE 10W-40; JASO MA, MA2; API SL; ACEA A3
8 - Tighten the engine oil filler cap.

Tightening torques (N*m)
Cover oil sump - Oil sump 11,0 ± 1,0 Nm