Fitting Guide - Piaggio Porter Window Regulator


By Christian Sorbello
1 minute read

montaggio alzacristallo piaggio porter

Fitting - Piaggio Porter Window Regulator

 1 - Insert the glass from the inside of the door, taking care not to knock it against the pillars. Refit the sealing gaskets.

alzavetro piaggio porter

2-  Using a suitable tool, secure the glass at the top.

alzavetro piaggio porter

3 - Refit the front glass channel

alzavetro piaggio porter

4 - Tighten the lower fixing screw of the front glass channel.

alzacristallo piaggio porter

5 - Tighten the upper fixing screw of the front glass channel

alzacristallo piaggio porter

6 - Insert the rear glass channel into its seat from below

alzacristallo piaggio porter

7 - Tighten the lower fixing screw of the rear glass channel

ricambi piaggio porter

8 - Insert the window regulator into its seat.

alzacristallo sinistro piaggio porter

9 - Tighten the fixing screws of the window regulator to the door

alzacristallo piaggio porter

10 - After positioning the glass onto the mechanism, temporarily use the knob until the threaded holes line up, so that the relevant screws can then be fitted.

alzacristallo piaggio porter

11 - Tighten the screws fixing the glass to the window regulator.

12- Remove the knob.

13 - Refit the trim panel

alzavetro alzacristallo piaggio porter

alzavetro alzacristallo piaggio porter