Aluminium & Mesh Side Extensions - Piaggio Porter
The Piaggio Porter Side Extensions aluminium and mesh, made by Officine Cucini are a solid alternative for landscapers and for anyone who needs to carry a bulky load.
Let's go through the whole fitting procedure together
1) Remove the 4 rivets (2 per side) that secure the top of the rear end plate of the drop side, and drill through with a 9 mm bit, going right through the drop side to the opposite side.
2) Assemble the 2 rear posts with the components shown in the photo (tighten the bolts partially: complete the tightening in the final stage, after making all the adjustments)
3) Fit the rear posts, securing them at the 2 holes made previously, for now with 2 screws. Make the third hole, tightening the third bolt only at the end, after adjusting the position of the drop sides
4) Assemble the front side extension tightening the upper and lower brackets to the aluminium end plate using the threaded galvanised plates shown in the photo
5) Screw the uprights of the side extension front at the 6 holes provided on the cab guard of the original load bed. The images show the mesh side extension kit, whereas in the case of the aluminium side extension kit rivet the two uprights of the side extension front onto the side extension itself, after screwing them to the 6 holes provided on the original load bed.
6) Fit all the side extensions placing a spacer washer between the original drop side and the side extension, and adjust its position
7) Unscrew the bolt that locks the original Piaggio release lever, removing the lever itself (we recommend placing the removed original components in the cab to hand them to the customer
8) Make all the necessary adjustments, then fit the missing third locking bolt for the rear uprights (see point 3) and tighten all the adjustment bolts.








