Piaggio Porter Brake Pedal Play Check
Hello to all Piaggio Porter enthusiasts — have you ever had a lot of play in your brake pedal too? Don't worry, we at Mondo Porter will show you how to check it and, above all, how to adjust it.
Here's how to check the pedal play:
Switch off the engine and press the brake pedal at least 5 times
to release the vacuum
in the brake servo. Press lightly on the
brake pedal by hand until you feel resistance,
then measure the play. Make sure the play
is within the specified value. Assembly clearances
Brake pedal play 2 ÷ 7 mm
«A» pedal in pressed position; «B» brake pedal
play;
It's very important to check the pedal travel, and if you don't know how, we'll show you.
Park the Porter on a flat surface.
Put the gearbox in neutral. Apply the handbrake.
With the engine running, press
the brake pedal several times. Press it with a force of about 30 kg and measure the distance between the top of the pedal and the front panel. Make sure the remaining travel is
within specification.
Assembly clearances
Brake pedal remaining travel > 85 mm
«A» front panel; «B» pedal in pressed position; «C» remaining travel;
If your pedal has a lot of play and needs adjusting, don't worry — we at Mondo Porter have thought of that too; here's how to adjust it:
- Loosen the push rod locknut (1).
- Turn the push rod (2) until the brake pedal
play is within specification. - Tighten the locknut (1) of the push rod.
- Check the adjustment of the switch (3)
of the brake light and adjust it if necessary.
