Piaggio Porter braking corrector technical sheet
Let's take a look at the technical data sheet for the Piaggio Porter brake pressure regulator
confirming its specifications and settings
What is the brake pressure regulator? What is it for? How does it work?
The LSPV (pressure regulator / brake compensator) regulates the hydraulic pressure of the proportioning valve according to the weight applied to the vehicle's rear axle.

-
KEY:
1. Side cross member
2. Rear axle
A = During operation with a light load
A' = During operation with a normal load
Pm = High hydraulic pressure of the rear master cylinder Pr = hydraulic pressure of the rear wheel cylinder
Description

KEY:
1. Sealing ring
2. O-ring
3. Cover
4. Plug
5. Retainer
6. Spring
7. Piston
8. Metal sealing gasket
9. O-Ring
Pm = Master cylinder hydraulic pressure Pf = Front brake hydraulic pressure
S = SPG thrust force
A2 = Large-diameter section of the piston Pr = Rear brake hydraulic pressure
F = Piston thrust force
A1 = Small-diameter section of the piston A3 = Small-diameter section of the piston
Settings and pressures

KEY:
PM = Master cylinder hydraulic pressure
PR = Rear brake hydraulic pressure
W = WHEN the front brake is operating
K = WHEN the SPG sensor is broken
1. PM <PF
The master cylinder pressure PM starts to rise. At this point, however, there is still clearance between the main section of the piston A2 , and the metal sealing gasket. Therefore the master cylinder pressure PM is transmitted to the rear brake PR .
PM = PR
2. PM = Pc
WHEN the master cylinder pressure PM reaches pressure PC at the turning point, the piston moves to the right of the figure above owing to the force balance. As a result, the piston comes into contact with the metal gasket.
PM x A1 = F + S
3. PM> PC
If the master cylinder pressure PM rises above PT the metal gasket opens and closes. As a result, the rear brake pressure rises according to the ratio of the piston's cross-sectional area.
1- [A1 / (A2-A3)]
Pr = Pm [1- (A1 / (A2-A3))] + (S + F) / (A2-A3)