Removal & Refitting Guide - Complete Piaggio Porter Engine
Here is a short guide to removing the Piaggio Porter engine
- Position the vehicle on the lift,
- Disconnect the negative (-) battery terminal, - Disconnect the electrical system connectors,
- Remove the air intake pipes,

- Disconnect the gearbox / clutch control linkages.
- Remove the fuel tank cap to reduce the internal pressure of the fuel system. - Disconnect the fuel supply pipes.
- Place a support platform under the engine and rest the engine on it,
- Remove the 4 fixings of the engine mount, two per side.
- Move the engine out from under the vehicle using a mobile trolley.

Fitting - Piaggio Porter Engine
To fit the engine to the vehicle, proceed as follows:
- Position the engine under the vehicle on the lift,
- Raise the engine, already pre-assembled in its engine mount, and
move it up to the vehicle. - Secure the engine/gearbox mount to the chassis at the specified torques.
- Secure the gearbox mount to the chassis at the specified torque. - Connect the gearbox / clutch control linkages.
- Connect the fuel pipes.
- Connect the electrical system connectors.
- Connect the air intake pipes.
- Connect the negative (-) battery terminal.