Topping Up the Cooling System Coolant - Piaggio Porter
Complete Guide: Topping Up the Cooling System Coolant
Carry out the following steps:
1 - Move the heater control lever to the "hot" position.

2 - Remove the front grille by pulling the top slightly towards you and lifting it upwards

3 - Unscrew the cap filler from the radiator
( we recommend always keeping a genuine Piaggio cap )

4 - Lift the driver's seat and unscrew the cap filler on the engine side.

5 - Position the vehicle on the lift.

6 - Get a suitable container, unscrew the drain plug of the radiator and let the coolant drain out. Clean and install the radiator drain plug to the prescribed torque.

9 - Continue pouring coolant through the filler hole of the radiator until it reaches the level of the hole itself. Install the cap on the radiator.

10 - Check that the coolant level in the expansion tank is between the LOW (minimum) and FULL (maximum) marks and top up if necessary.
Start the engine and bring it up to temperature so that the cooling circuit is force-circulated, and check that there are no leaks. Switch off the engine.
11 - As soon as the engine temperature drops, unscrew the cap filler of the radiator and check the coolant level. Top up if necessary and install the cap.

12 - Check the coolant level in the water reservoir . Add water until it reaches the FULL (maximum) level.
