Piaggio Porter Dashboard Removal
Removing the Piaggio Porter Dashboard
1 - Before starting work, disconnect the negative (-) terminal from the battery.

2 - Remove the instrument cluster by undoing the two side screws.
3 - Pull out the instrument cluster from the fascia.
4 - At the rear of the instrument cluster sits the connector. To release the plug from its housing, press the green tab and slide the safety catch to the left as shown in the following positions (1). After turning the safety catch to position (2), the connector can be removed.

5 - Pull the connector out of its seat on the instrument cluster

6 - Fit the connector into the new instrument cluster, slide the safety catch and click the green locking tab into place.

7 - Remove the centre fascia by taking out the two upper screws.

8 - Lift the fascia and disconnect the control switches from the connectors.

9 - Remove the two caps at the top of the dashboard

10 - Remove the side fixing screws of the dashboard

11 - Remove the centre tunnel with its screws.
12 - Disconnect the connectors of the devices in the centre tunnel and remove it

13 - Remove the fixing screws of the steering column shroud.

14 - Removing the steering column shroud.

15 - Remove the two fixing screws of the brake fluid reservoir.

16 - Remove the screws of the two fascia support posts.

17 - Release the ventilation control from the dashboard

18 - Remove the steering wheel locking nut.

19 - Disconnect the horn connector by gently pressing the tab with a screwdriver and pushing it upwards
20 - Disconnect the respective connectors from the light & indicator stalk switch.
21 - Remove the fixing screw of the light & indicator stalk switch with an Allen key.
22 - Pull the light & indicator stalk switch off the steering column.
23 - Remove the upper anchoring screws of the dashboard
24 - Unscrew the centre screw of the dashboard to release it completely.
25 - Remove the fascia of the dashboard by unhooking the two air duct pipes.









