Piaggio Porter Engine Speed Sensor
The rev sensor of the Piaggio Porter is located near the reaction bracket of the gear selection and engagement linkage.

It is an inductive-type sensor. It generates signals obtained from magnetic flux lines that close through the teeth of the reluctor wheel on which the sensor is positioned. The ECU powers the sensor and uses the signal to detect the rotation speed of the crankshaft.
Engine rev sensor wiring diagram Piaggio Porter

Pin Colour Description
| 1 | - | - |
| 2 | WR | negative rev sensor signal |
| 3 | OR | positive rev sensor signal |
The sensor is connected directly to the electronic control unit via vehicle/engine interface connectors. Check
Insert the tester probes (set to the ohm x 100 scale) between contacts 2 and 3 of the sensor connector. The resistance value must be between 600 - 750 ohm. Also check, in the event of a fault, the circuit integrity of the connection between the sensor and the ECU.