Piaggio Porter Lambda Sensor
Piaggio Porter Lambda Sensor
It is a sensor that transmits to the engine management ECU the information on the amount of oxygen present in the exhaust gases entering the catalytic converter.

By means of this sensor the engine ECU can maintain an optimal air-fuel mixture composition. The sensor provides a voltage signal that varies considerably when it is struck by the flow of exhaust gases of strictly stoichiometric composition.
The catalytic converter is fitted with two sensors (at the inlet and outlet of the exhaust gases) to monitor the efficiency of the catalytic converter itself. Any faults/anomalies in the lambda sensors lead to irregular engine operation, significant increases in fuel consumption and pollutant emissions beyond the permitted limits.
Functional checks on the component must be carried out with a suitable diagnostic tool connected to the EOBD connector.
The lambda sensors are powered by the main relay. With a tester and the ignition key switched on, it is possible to check for the presence of voltage at the connector terminals (harness side) at pins 1 and 2.
Piaggio Porter Lambda Sensor Wiring Diagram

PRE-CATALYST LAMBDA SENSOR CONNECTOR
Pin Colour Description
|
1 |
Y |
Front lambda sensor heater negative |
|
2 |
BY |
Main relay supply (D08_21) |
|
3 |
L |
Engine management ECU signal |
|
4 |
BrY |
Engine management ECU negative |
Pin Colour Description
|
1 |
Y |
Front lambda sensor heater negative |
|
2 |
BY |
Main relay supply (D08_21) |
|
3 |
L |
Engine management ECU signal |
|
4 |
BrY |
Engine management ECU negative |