Piaggio Porter Multitech Clutch Kit / Fitting and Removal


By Christian Sorbello
2 minute read

montaggio frizione piaggio porter multitech

Removal  / Piaggio Porter Multitech Clutch Kit

To carry out maintenance or replacement work on the shaft, the following components must be removed:


- Propshaft.

- Gearbox bellhousing.


1 - Fit the special tool to lock the flywheel, then remove the outer bolts of the pressure plate.

Smontaggio frizione piaggio porter

2 -  Remove the clutch disc and check the general condition and degree of wear

Frizione piaggio porter rmultitech

3 - Check the general condition and degree of wear of the disc clutch. Replace if necessary.

Frizione piaggio porter multitech

CLUTCH - CHECKS

Check the degree of wear or damage of the following components and replace if necessary.

Frizione piaggio porter multitech

- Pressure plate spring.
- Return spring.

Thrust bearing

1. Check that the thrust bearing rotates freely, without binding.

Rotate the thrust bearing while manually applying an axial force to the bearing. Make sure there are no abnormal signs of stiffness or obstruction.

Cuscinetto piaggio portatore
2. Check whether the thrust bearing hub shows signs of damage or wear.

Frizione piaggio porter multitech

Also check whether the contact surface of its stop and the sliding section of the housing show signs of damage or wear.

Fitting  /  Piaggio Porter Multitech Clutch Kit

1 - Before completing the assembly stage of the clutch, make sure the following points are observed.

Frizione piaggio porter

WARNING: Fit the clutch disc with the chamfered side on the splined hub, facing the flywheel.

2 - Carefully align the clutch disc with the flywheel hole, using a universal centring tool.

spingidisco frizione piaggio porter multitech

Any misalignment could cause considerable difficulty when inserting the shaft.

3 - Finally, fit the flywheel lock and tighten the pressure plate clutch to the prescribed torque.

kit frizione piaggio porter multitech