Piaggio Porter Multitech Engine Oil & Oil Filter Change


By Christian Sorbello
1 minute read

scarico olio motore piaggio porter multitech

Piaggio Porter Multitech Engine Oil Change 

1 - Start the engine and warm it up for a few minutes

2 - Switch off and lift the driver's seat

3 - Unscrew the engine oil filler cap

olio motore piaggio porter multitech

4 - position the vehicle on the lift.

olio motore piaggio poretr

5- Unscrew the centre screw on the lower engine guard ( see photo ) 

protezione motore piaggio porter

6 - Unscrew the side screw on the lower engine guard  ( see photo ) 

protezione motore piaggio porter

7 - Unscrew the side screw on the lower engine guard ( see photo ) 

protezione motore inferiore piaggio porter multitech

8 - Get a suitable container and unscrew the engine oil drain plug.

9 - Unscrew the engine oil drain plug ( see photo )  

scarico olio piaggio porter

Replacing Piaggio Porter Multitech Engine Oil Filter 

10 - Unscrew the engine oil filter with the correct wrench. Check and clean the seating surface of the filter.

scarico olio motore piaggio porter multitech  

11 - Lubricate the sealing ring of the new oil filter with engine oil before fitting it, then screw it on by hand until the sealing ring contacts the mounting surface

filtro olio piaggio porter benzina multitech 

 

12 - Tighten the oil filter by 3⁄4 of a turn by hand or with the correct wrench to the specified torque. Clean and fit the drain plug with a new gasket, observing the specified torque.

Tightening torques (N*m)

Oil filter - Cylinder block 14 ± 2 Nm

Engine oil drain plug - Engine oil sump 25 Nm