Fitting and Removal - Piaggio Porter Multitech Flywheel


By Christian Sorbello
1 minute read

Volano piaggio porter Multitech 1f000017

Fitting and removal guide, Piaggio Porter Multitech Flywheel 

Removal Piaggio Porter Multitech Flywheel 

To remove the flywheel proceed as follows: fit the special tool to the crankcase, as shown, to prevent the flywheel from rotating during the work.

Volano Piaggio Porter Multitech 1F000017

Unscrew the bolts on the perimeter coupling the drive plate and flywheel and remove the complete clutch.

Volano Piaggio Porter Multitech 1F000017

Unscrew the 6 bolts of the flywheel

Volano Piaggio Porter Multitech 1F000017

Remove the flywheel from the crankcase.

Volano Piaggio Porter Multitech 1F000017

Check the sealing ring / oil seal and replace if necessary.

Volano Piaggio Porter Multitech 1F000017

Check for abnormal wear or damage to the bearing inside the flywheel.

Volano Piaggio Porter Multitech 1F000017

Fitting Piaggio Porter Multitech Flywheel

Brush and blow out thoroughly to remove threadlocker residue from all the threads of the flywheel and of the bolts to be used.
Apply the prescribed sealant and hand-tighten the bolts.

Volano Piaggio Porter Multitech 1F000017

Tighten to the prescribed torque the 6 bolts of the flywheel.

Tightening torque (N * m)
Flywheel bolts - Crankshaft 65,5 ÷ 72,5 Nm

Volano Piaggio Porter Multitech 1F000017