Piaggio Porter Multitech Oil Pump - Fitting / Removal


By Christian Sorbello
1 minute read

monatggio e smontaggio pompa olio piaggio porter

Removing the Piaggio Porter Multitech Oil Pump

1 - To replace the oil pump you need to remove the tappet cover and the complete timing cover.

pompa olio piaggio porter multitech

2 - Remove all the timing cover screws to reach the oil pump.

pompa olio piaggio porter

3 - The oil pump is integrated into the lower part of the timing cover.

pompa olio piaggio porter

4 - Remove the «seger» circlip; to inspect and/or clean or replace the components of the pressure regulating valve.

pompa olio piaggio porter

5 - Remove the components from the oil over-pressure relief valve as follows:

pompa olio piaggio porter

- the «seger» circlip,- the spring thrust plate - the spring, - the plunger

Checks Oil Pump 

Check the integrity of the components and that the passages are clean, and if necessary also replace the oil pick-up pipe gasket.

pompa olio piaggio porter

Refitting Oil Pump 

1 - Carefully clean the mating surfaces.

pompa olio piaggio porter

2 - Refit the complete timing cover, first applying the recommended sealant around the perimeter of the cover and in particular at the points indicated and at the joints between the cylinder head and block.

pompa olio piaggio porter

Recommended products
Loctite 5699 sealing adhesive.

3 -Lock the timing cover onto the cylinder block, observing the tightening torques.

coppie di serraggio pompa olio piaggio porter

Tightening torques (N*m)

Timing chain cover M6 (a) - Cylinder block 11÷12 Nm Timing chain cover M8 (b) - Cylinder block 21÷25 Nm