Piaggio Porter Multitech Phase Sensor
The phase sensor, located on the timing cover, reads the signal coming from the intake valve control gear.
The signal generated by this sensor lets the engine management ECU recognise the engine phase during start-up synchronisation and which cylinder to inject into.

The phase sensor is of the inductive type. A semiconductor carrying a current and immersed in a magnetic field generates a potential difference across its terminals. If the current intensity is constant, the voltage generated depends on the strength of the magnetic field. If that intensity varies periodically, a modulated electrical signal is generated.

Phase sensor wiring diagram Piaggio Porter
Pin Colour Description
| 1 | B |
Earth D10_02 |
| 2 | L | Engine phase sensor |
| 3 | R | main relay power supply |
The sensor is powered directly by the vehicle voltage (12V). With the ignition key turned on, disconnect the connector from the sensor and, using a tester, check for voltage between pins 1 and 3 (about 12,5V). If there is no voltage, check the circuit integrity of the vehicle/engine interface connector, D09_07, and check for voltage between pins 5 and 16 of the latter.