Piaggio Porter Multitech Spark Plug / Removal


By Christian Sorbello
1 minute read

smontaggio candele piaggio porter multitech

10 easy steps to remove the spark plugs on your Piaggio Porter Multitech

Removal 

1 - Disconnect the negative terminal clamp from the battery.

piaggio porter battery, spark plugs

2 - Access the engine bay on the driver's side. Cut the cable-sheath retaining tie from the rail assembly bracket.

piaggio porter spark plugs

3 - Disconnect the fuel-injector connectors.

piaggio porter multitech spark plugs

4 - Disconnect the gas pressure/temperature sensor from the rail assembly.

 piaggio porter multitech spark plug removal

5 - Undo the screw (one of two) securing the rail assembly to the tappet cover.

piaggio porter multitech spark plug removal

6 - Undo the second screw securing the rail assembly to the tappet cover.

piaggio porter multitech spark plug removal

7 - Lift the rail assembly to gain access to the ignition coil; disconnect the electrical connector from the ignition coil by releasing the retaining clip.

piaggio porter multitech spark plug removal

8 - Undo the screw securing the ignition coil.

piaggio porter multitech ignition coil

9 - Carefully pull off the spark plug cap and visually inspect it to check its wear.

piaggio porter multitech ignition coil

 

10 - Undo the spark plug with the appropriate spanner, check its wear and replace it if necessary, or as indicated in the scheduled maintenance table.

Check the gap between the electrodes.

Electrode gap

0,8 ÷ 0,9 mm

piaggio porter multitech spark plug removal