Piaggio Porter Multitech Spark Plugs / Fitting


By Christian Sorbello
1 minute read

montaggio candele piaggio porter

9 Simple Steps to Fit the Spark Plugs on Your Piaggio Porter Multitech 

Fitting 

1 - Insert the spark plug into its housing at the correct angle and tighten with the proper spanner to the specified torque. Refit the spark plug cap.

candele piaggio porter multitech

 ** The fitting of new spark plugs must always be done with the ENGINE COLD **

Tightening torques (N*m)

Spark plug - Cylinder head 17 ± 2 Nm

 

2 - Tighten the fixing screw of the coil to the specified torque;

Tightening torques (N*m)

Ignition coil - Rocker cover 10 ± 1 Nm

MONTAGGIO BOBINA PIAGGIO PORTER

3 - Connect the electrical connector to the coil, securing it with its retaining clip; Position the rail assembly in its seat;

montaggio bobina e candela piaggio porter

4 - Tighten the screw (one of two) fixing the rail assembly to the rocker cover to the specified torque.

Tightening torques (N*m)

Rail support bracket - Long spacer 5,5 ± 1,5 Nm

montaggio candele bobina piaggio porter multitech

5 - Tighten the second screw fixing the rail assembly to the rocker cover to the specified torque.

Tightening torques (N*m)

Rail support bracket - Short spacer 5,5 ± 1,5 Nm

montaggio candele bobina piaggio porter multitech

6 - Connect the gas pressure/temperature sensor to the rail assembly.

sensore rail piaggio porter multitech , montaggio candele

7 - Connect the electrical connectors of the injectors.

montaggio candele bobina piaggio porter

8 - Position and close a new retaining clip for the cable conduits on the rail assembly bracket.

montaggio candele piaggio porter multitech

9 - Connect the negative battery terminal.

batteria piaggio porter , morsetto batteria , smontaggio candele