Guide to Replacing the Starter Motor on the Piaggio Porter NP6


By Christian Sorbello
2 minute read

Guida alla Sostituzione del Motorino di Avviamento nel Piaggio Porter NP6 - Mondo Porter

Guide to Replacing the Starter Motor on the Piaggio Porter NP6

The Piaggio Porter NP6 is a reliable vehicle for many businesses and individuals. One of the key components that keeps it running smoothly is the starter motor, essential for starting the engine. In this article, we will guide you through the process of replacing the starter motor on the Porter NP6, give you insights into its electrical system and offer valuable tips for keeping your vehicle in top condition.

Understanding the Starter Motor on the Porter NP6

The starter motor plays a fundamental role in the operation of the vehicle, cranking the engine and letting you set off on your journey. On the Piaggio Porter NP6, the starter motor is located under the right-hand seat. Its removal and replacement call for attention to detail and a few specific steps.

Removing the Starter Motor

Here is a step-by-step guide to removing the starter motor:

  1. Preliminaries: Before you start, place the vehicle on a lift and disconnect the negative terminal of the battery.
  2. Removing components:
    • Remove the throttle body.
    • Remove the under-engine guard.
  3. Undoing the bolts:
    • Undo the fixing nut of the starter motor cable.
    • Disconnect the electrical connection of the starter motor.
    • Undo the lower fixing bolt of the starter motor.
    • Moving the lift, undo the upper fixing bolt.
  4. Final removal: Slide out and remove the starter motor.

Fitting the New Starter Motor

Once the old starter motor has been removed, here is how to fit the new one:

  1. Positioning: Position the new starter motor in its seat.
  2. Securing the bolts:
    • Tighten the upper bolt to the prescribed torque (50 ± 5 Nm).
    • Moving the lift, tighten the lower bolt to the prescribed torque.
  3. Electrical connections:
    • Reconnect the electrical connection of the starter motor.
    • Tighten the fixing nut of the starter motor cable.
  4. Refitting components:
    • Refit the under-engine guard.
    • Refit the throttle body.
    • Reconnect the negative terminal of the battery.

With the new starter motor fitted and everything back in place, your Piaggio Porter NP6 is ready to run smoothly.

Ongoing Maintenance

To keep your Piaggio Porter NP6 running at its best:

  • Check the electrical components regularly: Make sure the electrical connections are secure and free from corrosion.
  • Replace worn parts: Components such as the starter motor, the battery and the alternator should be checked and replaced if worn.

You can buy the starter motor for your Piaggio Porter NP6 HERE = https://www.mondoporter.com/en/products/motorino-di-avviamento-piaggio-porter-np6