Piaggio Porter Propshaft - Installation
Installation
1. Apply gear oil to the inner and outer sides of the sleeve as shown in the figure.

2. Insert the propshaft on the gearbox side.
3. Fit the propshaft, aligning it with reference mark A on the differential flange.

4. Install the fixing bolts with new washers.
5. Tighten the fixing bolts to the specified torque, evenly and gradually.
6. Rotate the propshaft and check that it does not bind and makes no abnormal noise.
Tightening torques (N*m)
Universal joint - Rear differential flange 39÷54
