Piaggio Porter Windscreen Removal / Fitting


By Christian Sorbello
2 minute read

montaggio vetro parabrezza piaggio porter

 Removal / Fitting Piaggio Porter Windscreen 

Removal (to be carried out by one person, in due time)
1 . Using a bamboo spatula (or a flat-head screwdriver, etc.) remove the seal from the body shell by pressing on the edge.
This operation MUST be carried out from inside the cab.

piaggio porter windscreen removal

2. Remove the windscreen by pressing and, levering from the inside, lift the upper part of the sealing gasket at both ends.

Remove the windscreen complete with its sealing gasket.

AT THIS POINT, MAKE SURE TO APPLY EQUAL FORCE ON THE GLASS. ALSO, HOLD THE GLASS from the outside SO THAT IT CANNOT come out OF ITS SEAT.

Fitting Piaggio Porter Windscreen

Installation (to be carried out by one person, in due time)


1
. Carry out the following preliminary operations:

- Secure the sealing gasket onto the windscreen glass.

- Prepare a cord « A » for the job as shown in the figure.

Piaggio Porter windscreen removal / refitting
- Apply soapy water around the perimeter of the seal «B» sealing so that it slides more easily.

Piaggio Porter windscreen fitting

2. Fit the windscreen and its seal onto the frame so that they are correctly positioned in their seat.


Also ensure that the two ends of the cord hang inside the vehicle.

3. Pull the cord, again from inside the cab, while a second person, from the outside, taps with the palms of their hands on the surface of the windscreen next to the seal to seat the seal properly in its housing.

piaggio porter windscreen fitting

4. To install the windscreen, tap on it with the palms of your hand.

5. Wiper arm front, and blade. For the installation position, see the figure.

piaggio porter windscreen