Removal Guide - Piaggio Porter Rear Shock Absorbers


By Christian Sorbello
1 minute read

ammortizzatori posteriori piaggio porter

Removing the Piaggio Porter Rear Shock Absorbers

1 - Raise the vehicle on a vehicle lift.

2- Support the differential housing with a workshop jack.

3 - Unscrew the lower fixing nut of the rear shock absorber from the differential half-shaft.

ammortizzatore piaggio porter 

4 - Unscrew the fixing nut of the rear shock absorber from the chassis.
Slide out the shock absorber.

ammortizzatore posteriore piaggio porter

 

5 - Check the operation of the shock absorber.

Push the piston rod downwards, checking that the pull is uniform throughout the stroke and that there is no unusual resistance or noise.

ammortizzatore posteriore piaggio porter

Push the piston rod downwards and release it, making sure it returns at a constant speed. If any defects or faults are found, replace the shock absorber.

Fitting - Piaggio Porter Rear Shock Absorbers

To refit, carry out the removal steps in reverse order, observing the tightening torques.

ammortizzatori posteriori piaggio porter

Tightening torques (N*m)

Rear shock absorbers - Upper and lower fixing 51 ± 12,8 Nm

 

ammortizzatori posteriori piaggio porter

ammortizzatori posteriori piaggio porter