Removing and Fitting the Clutch on the Piaggio Porter NP6


By Christian Sorbello
2 minute read

Smontaggio e Montaggio della Frizione del Piaggio Porter NP6 - Mondo Porter

Complete Guide to Removing and Fitting the Clutch on the Piaggio Porter NP6

The Piaggio Porter NP6 is a commercial vehicle highly valued for its versatility and reliability. One of the most common maintenance jobs on this model is clutch replacement. This guide will give you all the information you need to correctly carry out the removal and fitting of the clutch on the Piaggio Porter NP6, following SEO best practices to ensure good indexing on search engines.

Introduction

The clutch is an essential vehicle component that temporarily disconnects the engine from the wheels, enabling gear changes. A worn clutch can seriously compromise the vehicle's performance, making its replacement necessary. In this guide, we'll explore the detailed steps for removing and fitting the clutch on the Porter NP6, ensuring a safe and properly done job.

Tools Required

To carry out the job correctly, you'll need the following tools:

  • Clutch centring tool (Tool code: 021028Y)
  • Torque wrenches
  • Oil collection containers
  • Vehicle lift

Removing the Clutch

  1. Preparing the Vehicle:

    • Position the vehicle on the lift.
    • Disconnect the negative battery terminal to avoid short circuits.
  2. Removing the Gearbox and Propshaft:

    • Remove the propshaft.
    • Remove the gearbox by undoing the clutch bellhousing fixing screws.
  3. Removing the Clutch:

    • Undo the clutch bellhousing screws.
    • Remove the complete clutch.

Fitting the Clutch

  1. Inspection and Preparation:

    • Visually inspect the clutch disc and cover plate for any signs of wear or damage.
    • Use the specific clutch centring tool to correctly position the disc and cover plate.
  2. Fitting the Clutch:

    • Insert the specific tool through the hole in the complete clutch.
    • Position the clutch in place and tighten the fixing screws to the specified torque (20 ± 2 Nm for the clutch cover - flywheel).

  1. Refitting the Gearbox and Propshaft:

    • Fit the gearbox.
    • Refit the propshaft.
    • Reconnect the negative battery terminal.

Clutch Hydraulic Actuator

  1. Removing the Actuator:

    • Position the vehicle on the lift and drain the brake/clutch fluid system.
    • Undo the fixing screws of the clutch hydraulic actuator and remove it.
  2. Fitting the Actuator:

    • Fit the clutch hydraulic actuator in place and tighten the screws to the specified torque (21 - 25 Nm).
    • Carry out the bleeding procedure for the brake/clutch fluid system.

Final Considerations

Once the clutch has been fitted, it's essential to check that the system works correctly. Check that the clutch pedal has the correct free play and that all connections are properly tightened and free of leaks.