Replacing the Piaggio Porter NP6 Front Suspension Arm


By Christian Sorbello
2 minute read

Sostituzione Braccio di Sospensione Anteriore del Piaggio Porter NP6 - Mondo Porter

How to Replace the Front Suspension Arm on the Piaggio Porter NP6

Introduction

Maintaining the Piaggio Porter NP6 is essential to ensure the safety and longevity of the vehicle. One of the most common jobs is replacing the front suspension arm. In this guide, we will explain step by step how to carry out this job correctly. Following the instructions carefully will ensure a safe and effective installation.

Tools Required

  • Vehicle lift
  • Torque wrench
  • Set of Allen keys
  • Replacement bolts (if required)

Removing the Suspension Arm

  1. Preparing the Vehicle

    • Place the vehicle on the lift. This ensures stability and safety during the job.
  2. Removing the Securing Bolts

    • Undo the lower securing bolt connecting the wheel upright to the lower suspension arm.
    • Repeat the operation for the other lower securing bolt.
  3. Undoing the Bolt at the Cross Member

    • Undo the bolt connecting the suspension arm to the cross member. Keep the bolts if they are in good condition or replace them with new ones if necessary.
  4. Removing the Suspension Arm

    • Carefully remove the front suspension arm. Make sure the part is removed without damaging other components of the vehicle.

Fitting the New Suspension Arm

  1. Fitting the New Arm

    • Place the new lower suspension arm into position. Make sure it is correctly aligned.
  2. Securing the Bolts

    • Tighten the bolts of the suspension arm to the cross member to the specified torque of 80 ± 8 Nm using a torque wrench. This ensures the bolts are correctly tightened without the risk of loosening or breakage.
    • Also tighten the lower bolts securing the strut to the front suspension arm to the same specified torque.
  3. Final Check

    • Lower the vehicle off the lift.
    • Check the vehicle geometry to make sure all components are correctly fitted and that the vehicle is safe to drive.

Conclusion

Replacing the front suspension arm on the Piaggio Porter NP6 is a crucial job for keeping the vehicle in optimum condition. By following this guide, you can carry out the job safely and professionally. Always remember to use suitable tools and to observe the specified tightening torques to ensure the vehicle's safety.

You Can Buy the Lower Arms for the Piaggio Porter NP6 here:

Lower Left Arm ( driver's side ) Piaggio Porter NP6 = https://www.mondoporter.com/en/products/braccio-sospensione-inferiore-sinistro-piaggio-porter-np6

Lower Right Arm ( passenger side ) Piaggio Porter NP6 = https://www.mondoporter.com/en/products/braccio-sospensione-inferiore-destro-piaggio-porter-np6