Replacing the Front Wheel Hub on the Piaggio Porter NP6


By Christian Sorbello
2 minute read

Sostituzione del Mozzo Anteriore del Piaggio Porter NP6 - Mondo Porter

Complete Guide to Replacing the Front Wheel Hub on the Piaggio Porter NP6

Introduction

Proper maintenance of the Piaggio Porter NP6 is essential to ensure the safety and longevity of the vehicle. One of the most important jobs is replacing the front wheel hub. In this article, we will guide you step by step through the process of removing and fitting the front wheel hub, providing all the information needed to carry out the job safely and efficiently.

Tools Required

  • Vehicle lift
  • Torque wrench
  • Special tool 021030Y (hub locking lever)
  • Set of Allen keys
  • Replacement screws and bolts (if required)

Removing the Front Wheel Hub

For Twin Wheel (dual-wheel) Versions

  1. Preparing the Vehicle

    • Place the vehicle on the lift and remove the relevant front wheel.
  2. Removing the Hub

    • Use special tool 021030Y to undo the hub securing bolts.
    • Slide out and remove the front wheel hub.
  3. Further Dismantling for Twin Wheels

    • Clamp the wheel hub assembly in a vice.
    • Undo and remove the hub securing screws.
    • Remove the wheel-to-hub mounting flange and the brake disc.
    • Undo and remove the hub retaining nut.

For Single Wheel Versions

  1. Preparing the Vehicle

    • Place the vehicle on the lift and remove the relevant wheel.
    • Remove the front brake disc.
  2. Removing the Hub

    • Use a suitable tool to remove the cap of the wheel hub nut.
    • Undo the front wheel hub retaining nut and slide out the wheel hub.

Fitting the New Front Wheel Hub

For Twin Wheel (dual-wheel) Versions

  1. Fitting the Hub

    • Place the new front wheel hub into position.
    • Bring the hub securing bolts up without tightening them.
    • Use special tool 021030Y to tighten the bolts to the specified torque of 155 ± 15 Nm.
  2. Completion

    • Refit the relevant front wheel.
    • Lower the vehicle off the lift and check the geometry.

For Single Wheel Versions

  1. Fitting the Hub

    • Place the new wheel hub into position.
    • Tighten the new wheel hub retaining nut to the specified torque of 205 ± 20 Nm.
    • Use a suitable tool to stake the retaining nut and fit the cap.
  2. Completion

    • Refit the front brake disc and the relevant wheel.
    • Lower the vehicle off the lift and check the geometry.

Conclusion

Replacing the front wheel hub on the Piaggio Porter NP6 is an essential job for keeping the vehicle in optimum condition. Carefully following this guide ensures a correct and safe installation. Always remember to use suitable tools and to observe the specified tightening torques.

You Can Buy the Front Wheel Hub for the Piaggio Porter NP6 here = https://www.mondoporter.com/en/products/mozzo-ruota-anteriore-piaggio-porter-np6