Replacing the Side Window Glass on the Piaggio Porter NP6
Complete Guide to Replacing the Side Window Glass of the Piaggio Porter NP6
Introduction
Maintaining the side window glass of the Piaggio Porter NP6 is essential to ensure safety and visibility while driving. In this guide, we'll look at how to remove and replace the front side windows, including the inner and outer window scraper seals. By following these steps carefully, you can carry out the job safely and efficiently.
Tools Required
- Vehicle lift
- Set of Allen keys
- Trim removal knife
- New seals and side windows (if required)
Removing the Front Side Glass Seal
-
Preparing the Vehicle
- Disconnect the negative battery terminal to prevent short circuits.
- Remove the exterior wing mirror and the front glass.
-
Removing the Seal

- Prise off and remove the front side glass seal.
Fitting the Front Side Glass Seal
-
Installing the Seal
- Fit and seat the new front side glass seal.
- Refit the front glass and the exterior wing mirror.
- Reconnect the negative battery terminal.
Removing and Fitting the Outer Window Scraper Seal
-
Removing the Outer Window Scraper Seal
- Lower the front glass fully.
- Use a trim removal knife to remove the outer window scraper seal.
-
Installing the New Seal
- Fit and seat the new outer window scraper seal.
- Raise the glass fully.
Removing and Fitting the Inner Window Scraper Seal
-
Removing the Inner Window Scraper Seal
- Lower the front glass fully.
- Disconnect the negative battery terminal.
- Remove the door panel and use a trim removal knife to remove the inner window scraper seal.
-
Installing the New Seal
- Fit and seat the new inner window scraper seal.
- Refit the door panel and reconnect the negative battery terminal.
- Raise the glass fully.
Removing the Front Side Glass
-
Preparing for Removal
- Disconnect the negative battery terminal.
- Remove the door panel, the front door water shield, and the inner and outer window scraper seals.
-
Removing the Glass
- Position the glass so that the inspection holes line up with the fixing screws.
- Temporarily connect the window switch panel and the negative battery terminal.
- Undo the fixing screws and remove the front side glass.
- Position the glass so that the inspection holes line up with the fixing screws.
Fitting the New Front Side Glass
-
Installing the New Glass
- Position the new front side glass and tighten the fixing screws.
- Lower the glass fully.
- Disconnect the negative battery terminal and the electrical connections of the window switch panel.
-
Completing the Assembly
- Refit the outer and inner window scraper seals.
- Refit the front door water shield and the door panel.
- Reconnect the negative battery terminal.
Conclusion
Replacing the side window glass on the Piaggio Porter NP6 is a job that calls for attention to detail and the right tools. By following this guide, you can carry out the work safely and effectively, keeping your vehicle both functional and looking its best.