Piaggio Porter 1.3 Petrol Multitech Timing
TIMING CHAIN
REMOVAL
To check, clean or replace: the timing chain, crankshaft sprocket, the chain tensioner or the chain guide rails , remove the following com- ponents:
- Oil sump and pick-up - Tappet cover - Timing cover.

Remove the cover of the chain tensioner from the moving chain guide rail and the chain tensioner.

Remove the fixed chain guide.

Remove the chain guide (moving).

Remove the tensioner and check that the oil passage holes are clear; if not, clean them with compressed air.

Remove the timing chain, lifting it off the camshafts and the crankshaft sprocket.

TIMING CHAIN - CHECKS
Before refitting the components, check that the shoe anti-wear lining on the moving chain guide is not worn or damaged; if it is, replace it.

Crankshaft sprocket, check that the surfaces and teeth of the crankshaft sprocket are not scored, worn or damaged.
Timing chain, check that the chain links are not worn or damaged.
If so, replace.

Chain tensioner; check that the end-stop tooth (1) and the toothed surface (2) of the plunger are not worn or damaged; if they are, replace the chain tensioner.

Refitting
Rotate the crankshaft until the key aligns with the mark on the cylinder block.

Position the two camshafts with the arrows stamped facing upwards.
Fit the timing chain with the two blue links aligned with the arrows.

Align the third blue link of the chain with the lower groove of the crankshaft sprocket, so that cylinder no.4 is at TDC on the compression stroke.

Fit the tensioner, applying light pressure on the end-stop tooth so the plunger can compress freely.
Tightening torques (N * m)
Chain tensioner - Cylinder block 11 Nm

Compress and lock the plunger with a pin.

Fit the moving chain guide.
Tightening torques (N * m)
Chain guide rail - Cylinder block 9 Nm
