Removal / Fitting - Piaggio Porter Water Pump B010236


By Christian Sorbello
1 minute read

Pompa Acqua Piaggio Porter B010236

Guide to fitting and removing the water pump  Piaggio Porter Multitech Code B010236

Removal Water Pump

Before removing the water pump drain the cooling system.
- Loosen the alternator adjuster and remove the auxiliary belt.

- disconnect the water inlet pipe.

- Remove the water pump by unscrewing the fixing screws from the cylinder block.

Pompa Acqua Piaggio Porter B010236

Check the condition of the gasket; replacement is recommended every time the pump is removed.
Check that the impeller turns smoothly and evenly, without binding.

NOTE: The pump cannot be overhauled, so if any faults are found replace the complete water pump.

Pompa Acqua Piaggio Porter B010236

Fitting Water Pump

Fit the water pump and tighten to the specified torque.


Then refit all the previously removed components in reverse order, and top the cooling system back up to the correct level.

Pompa Acqua Piaggio Porter B010236

Tightening torques (N*m) Water pump - Cylinder block 22 Nm