Water Sensor / Thermoswitch Check Piaggio Porter 1.3 16V


By Christian Sorbello
2 minute read

 sensore - termo interruttore acqua piaggio porter 1.3 benzina

Hello to all Piaggio Porter enthusiasts, in this article we'll show you how to remove the radiator thermoswitch and how to check that it is working correctly.

  1. First of all, disconnect the negative (-) battery terminal.
  2. Drain all the coolant.
  3. Disconnect the connector from the radiator
    thermoswitch.
  4. Remove the radiator thermoswitch from the radiator hose.
sensore - termo interruttore acqua piaggio porter 1.3 benzina

 

 

 

Once you've removed the thermoswitch from the radiator hose, not sure how to check whether it works? Don't worry, we've thought of that too. Here's how:

sensore - termo interruttore acqua piaggio porter 1.3 benzina

  1. Connect an ohmmeter between terminals A and B of the
    radiator thermoswitch.
  2. Place the heat-sensing section
    of the switch in a water bath. (As shown in the image alongside).
  3. Heat the water to a temperature of 93°C. Check for
    continuity between terminals A - B of the radiator
    thermoswitch. If there is no continuity, carry outsensore - termo interruttore acqua piaggio porter 1.3 benzina

    the following checks.
  4. Raise the water temperature to 97°C. Check
    for continuity between terminals A and
    B of the switch. If there is no continuity, replace
    the switch.
  5. Raise the water temperature to 94°C. Check
    that there is no continuity between terminals A - B
    of the switch. If there is continuity,
    carry out the following checks.
  6. Raise the water temperature to 85°C. Check
    that there is no continuity between terminals A - B of the switch.
    If there is continuity,
    replace the switch.

Once you've confirmed that your switch is working correctly, refit the thermoswitch. Here's how:

sensore - termo interruttore acqua piaggio porter 1.3 benzina
  1. Clean the threaded part of the switch, then we recommend wrapping the thread with adhesive tape.
  2. Once done, fit the radiator thermoswitch onto the radiator hose.
  3. Fill with coolant.
  4. Connect the negative (-) battery terminal.sensore - termo interruttore acqua piaggio porter 1.3 benzina
  5. Start the engine and check for water
    leaks.